In either case once you re ready to begin choose a side of the door to begin with and start lining the molding up in the exact spots you measured and marked earlier.
Installing trim around sliding glass door.
Make sure the screws aren t exposed.
Replacing sliding glass doors.
Use expanding foam insulation to seal any gaps between the door frame and wall.
Replacing sliding glass doors.
Secure the threshold to the door with screws.
Part of the series.
If this is the case it is recommended to put the molding up around your sliding glass door piece by piece.
Trim with a 1 8 inch gap after the flooring has been laid.
Secure the first piece with your carpentry nails.
Nail up the large base photo 13.
Cut all the base extra long rough cut all the baseboards about 2 in.
Threshold molding can be reused on sliding gl.
Measure the lip of the threshold s trim and leave enough clearance between the door and the flooring to install the threshold.
Nail the cap and shoe.
Use a putty knife to remove the excess.
Cover the foam insulation with trim and add a small amount of caulk to the visible joint.