For best results the stain should be applied within 48 hours of the bleach treatment.
How to treat wood siding next to deck.
Pry off as many of the intact sections as possible.
Step 2 sand the entire surface of the wood along the grain with a sander and 250 grit sandpaper to make it smooth.
You don t need to use fans or tools to help aid in the process.
But when applying the oils a light touch is what you need.
Wash the wood with soap and water and allow it to dry completely.
Paint can hide wood rot so poke the siding with the tip of the.
Step 1 treat with a bleach solution since white pine the wood selected for the exterior logs has a tendency to grow mold the exterior logs were prepped with a bleach solution before staining.
If your home has wood siding examine the siding around and beneath the windows for signs of swelling or discoloration.
Following this the wood needs to fully air dry.
Ipe wood throws the excess oil right back at you.
Be sure to use safety glasses.
Then slip flashing behind the siding covering the top edge of the ledger.
There are different wood sealing options for outdoor use but the best choice is often related to the specific project.
While standing on the ground or on a ladder next to the deck use a claw hammer or pry bar to remove rotten wood deck boards.
A light touch is all it needs.
Some options to treat untreated wood are wood oils top coatings sealers and stain sealant combo products.
Don t use film forming coatings.
They may be great for boats that have teak wood and such but not so much for your deck.
With an oiled surface clean the wood with a pressure washer apply a coat of wood bleach let it stand per the manufacturer s instructions and pressure wash again.
To do so start by cleaning the wood and drying up the remaining water.
It is this board that on every deck i have inspected is improperly installed flashed.
The easiest way how to treat untreated wood for outdoor use is to apply a wood sealer.
The board on your deck that is attached to your home is called the ledger board.
Hand sand corners edges and other areas difficult to reach with the sander.
At this point you can apply a fresh coat of oil or oil stain.
Make the outline large enough to include space for the deck boards on top the ledger and any trim boards on the sides.
You most certainly need to use penetrating oils to help the wood keep that dark color.
Snap a chalk line cut out the siding and tack up the ledger board.
Start by making an outline on the siding where you want to position the ledger board.
After intact sections are removed turn the boards over and pound out the nails from the back.